Clip-Mounted Insect Screen
Clip-mounted insect screen — the fixed frame locks with retainers on the joinery edge. Tool-free lowering and seasonal storage.
The Retainer's Working Form
In the clipped arrangement the connection is undertaken not by the panel but by small retainers passing onto the joinery edge. The retainer mouth grips the profile edge; when the frame is pushed with pressure the spring form draws the panel toward the channel.
No tool comes into play at lowering. When the panel edge is lifted and pulled the mouths free and the frame separates; refitting is the reverse of the same movement.
Fitting and Lowering
If the retainer points are right the set-up is single-person and takes a minute.
- 1
The points are decided
Opposite retainer places are chosen on the joinery edge. An unbalanced distribution leads the panel to run to one side.
- 2
The retainers seat
The clips are seated onto the edge plane. A retainer whose base does not stay fixed moves at panel movement.
- 3
The frame passes with pressure
The panel is first approached to the mouths from the top edge, then the bottom edge is pushed and locked.
- 4
The lock check is done
Each retainer's full passing onto the panel is verified visually and by hand. A half-passed point gives sound at the first wind.
- 5
At lowering the edge is lifted
The panel is lifted slightly from its bottom edge and freed from the mouths. It is pulled straight, not dragged.
Whom Is the Clipped Arrangement For?
The seasonal user
For a user taking the panel down and storing it when winter comes the snap-off speed is the core value. No tool or second person is needed.
The frequent washer
Those wanting to take the mesh and profile down and clean them see this arrangement's practicality at the first wash.
Joinery not wanting a hole
The retainer bases seat hole-free in most applications. The joinery surface stays mark-free.
Housing with estate rules
In estates having a ban on intervening to the outer face a recess-fitted clipped panel complies with the regulation.
The Difference Between Clipped and Screwed
Both are mechanical connections; the point they part at is the removal intent and the mark.
| Criterion | Clipped | Screwed |
|---|---|---|
| Removal | Tool-free, single move | A screwdriver is needed |
| Mark on surface | Stays mark-free | A hole mark remains |
| Façade endurance | Sufficient in ordinary wind | Fixed even at a hard impact |
| Panel weight | At standard sizes | On wide panels too |
The Sound of an Unseated Retainer
A thin gap seen at the panel edge or a hollow sound coming at closing reports a retainer not fully passing. When the point is pressed by hand and seated the sound stops.
In long use the retainer count decides the panel behaviour. A missing point produces a gap at the corner and leakage at the mesh edge; evenly distributed mouths squeeze the panel's four edges equally.
Questions About Clip-Mounted Insect Screen
How is a clipped insect screen stored in winter?
Does the clip leave a mark on the joinery?
Does a clip work on every joinery?
Related pages: Screw-Mounted Insect Screen · Surface-Mounted Fixed Insect Screen · Insect Screen Systems
Send the Joinery Edge
With the edge profile's close visual the retainer suitability and the point arrangement are recommended.
