Recess-Mounted Venetian Blind
Recess-mounted Venetian blind — the rail seats into the window recess. Depth condition, tolerance and the cleanest look.
The Rail Sinking Into the Recess
In a recess set-up the headrail sits on the window void's inner wall and the blind runs inside the recess. Seen from outside only the slats are visible; the rail stays on the same plane as the wall line.
This position is the Venetian's cleanest-looking form but its price is the recess itself. Sufficient depth must exist for the rail, the slat pack and the tilt mechanism.
Depth and Placement Conditions
Flush set-up passes four checks. If one does not fit, the plane changes.
| Check | Required | If It Does Not Fit |
|---|---|---|
| Recess depth | A share swallowing rail and slat pack | The rail stays out front; move to wall |
| Side tolerance | A symmetric narrowing share | The rail jams or slides to one side |
| Sash opening | No clash with the inward-opening sash | The sash touches the blind; wall is chosen |
| Casing protrusion | A gap behind the rail | The rail is brought forward; the look changes |
What the Flush Position Brings
Lowest edge leakage
Since the blind runs inside the recess light leaks only from the tolerance share. It cannot be compared with a rail standing on the wall.
Free window sill
If the sill top is occupied the flush blind does not clash with it. Pots and décor stay in place.
Integrated look
When the rail sinks to the wall line the window looks as if it carries its own accessory.
Radiator freedom
A blind staying inside the recess moves away from the radiator in front of the window and does not block the heat flow.
The Recess Set-Up
The measurement is not a single value; the recess is read from three points.
- 1
The recess is measured at three points
Top, middle and bottom widths are read separately; the narrowest value gives the rail length.
- 2
The tolerance share is deducted
The share dropped from the finished size lets the rail sit comfortably rather than scrape the recess.
- 3
The points are screwed to the inner wall
The connections are marked on the rail line; the recess side walls are sought to be solid.
- 4
The rail is locked and tested
The slats are lowered fully and closed; the clash with the sash opening is probed one last time.
A Recess Whose Depth Falls Short
If the depth can barely swallow half the rail the choice splits in two: either it is passed to wall mounting or a thinner-profiled rail series is turned to.
A half-flush look is not acceptable. A rail staying out front is both an aesthetic and a function loss; the slat pack hangs outside the recess and can clash with the sill.
Questions About Recess-Mounted Venetian Blind
How is the measurement taken in a recess?
Is recess possible on an inward-opening window?
How deep must the recess be?
Related pages: Wall-Mounted Venetian Blind · On-Sash Venetian Blind · Venetian Blind Systems
Send the Recess Measurement
Once the depth and the three-point width are shared the recess suitability is finalised.
